RGH Install guide - Pls correct me if I'm wrong

rpugsley

Noob Account
Mar 14, 2012
5
0
First of all, I'm new here, so Hello everyone.

I bought the XECUTER COOLRUNNER PHAT BUNDLE and Xecuter NAND-X from xconsoles.com and I'll do the RGH in my Banned Falcon next week.

I'm still with doubts maybe someone could clarify.

-Using this guide I will solder the QCB for Nand-x and CoolRunner. Using this wire layout. Dump my nand with Nand-x then program the CoolRunner. After all, remove nand-x cables from QCBs.

I saw about protecting eFuses,so I will take out the R6T3.

Close everything and enjoy,

is that all correct or I forgot anything?

Thanks!
 

stevebentley27

Full Member
Jan 21, 2010
25
0
wales
welcome to the forums but the guide that uve linked to is a non tx site !!!! theres loads of guide on here that will guide u through the process they certainley helped me i suggest you watch martin c's soldering videos too as its always best as if uve got any problems thats the main thing that will be causing it ,any help u may need there is always some 1 on here that will be able to help as long as u have read thru and searched 1st
 

mihaiviorel

Full Member
Jan 4, 2012
84
0
Romania
This and [ame="http://www.youtube.com/watch?v=OkuhC7exeow"]this[/ame] helped me very much. If you are using flux, try to clean the pads with some alcohol after soldering the wires because it will damage your pads in time.
 
  • Like
Reactions: rpugsley