installation problem

[crazed-cracker]

When installing the wire next to the hana chips I knocked off one of the very small blocks next to the hana chip. Now the console doesn't turn on. How cam I fix this. Its a slim

 

[hodgie]

yeah, it actually a pretty simple fix.
http://www.team-xecuter.com/forums/showthread.php?t=74992
first one listed. there are a couple more tut's as well.

or are you talking about the resistors? it would be the same process, though mostly.

 

[crazed-cracker]

The solder point is fine. I am not sure what its called but I think it may be called a resistor

 

[x360ccm]

post pic of your prob.

 

[RROD!]

if you knocked off the resistor then i would think you have ripped off the pads too unless what you did was plaster it with solder and thats how it come off would you please post a pic so we can see if it is the resistor if its b point that been knocked off is a smd 33 ohms resistor but you can use a thru hole it will be fine but best you still post a pic first

 

[crazed-cracker]

I will post one when I get home.

 

[crazed-cracker]

I wasnt paying attention and lifted them with solder. They were not ripped off. The spots are R3B15 and R3B17.

 

[x360ccm]

put 34 ohms resistors back. and it will power on.

 

[Martin C]

Don't do any more with this. Send it to someone to fix before you kill it (unless that's your intention).

Putting them back is not as easy as taking them off.

 

[crazed-cracker]

OK. Who can i send my console to and for how much?

 

[xbox360 hacker]

Thats a very simple fix as all the pads are still perfect. Soldering those tiny resistors are very tricky for the inexperienced. Best to send it off to a pro while it looks like that mate.

 

[crazed-cracker]

Who is someone in the USA that can fix this

 

[crazed-cracker]

Can someone please tell me who can do this fix in the USA?

 

[x360ccm]

look here i sure one of them will sort it for you.

http://team-xecuter.com/forums/forumdisplay.php?f=150

rdubbs or xmods as you in the usa.

 

[sick360mods]

i can do for 20 for the fix and if u want ill install your coolrunner and put freeboot on it for additional 50

 

[crazed-cracker]

No i just need it fixed I can do the CR install thanks though.

 

[mafia 5k]

Can someone please tell me who can do this fix in the USA?

hey cracker , i think i have seen you from ttg

i have fixed a bunch of these before your pads look good so i can 100% get it booting again you know hwo to contact me

 

[whoseanthony]

I can fix the whole setup for you and get the cr working for $20

 

[mafia 5k]

No i just need it fixed I can do the CR install thanks though.

i persoanlly would think you can handle this - here is how

go to radio shack pick up some 330 ohm resistors cut them down tin the ends and solder them in where you removed the old SMD's it should boot right up for you

 

[Krafter]

i persoanlly would think you can handle this - here is how

go to radio shack pick up some 330 ohm resistors cut them down tin the ends and solder them in where you removed the old SMD's it should boot right up for you

33 ohm not a 330 ohm.