So im dieing over here ive modded 3 times before but this one is killin me.
I did the pin header and it wouldnt boot it fragged when the chip was enabled.
When disabled it booted to the microsoft dashboard.
A couple of the pins were longer than other (basically the soldering wasnt good) so i took the header out and tried the wiring diagram on http://www.team-xecuter.com/forums/showthr...light=x2.6+wire )
With that i still got the same problem - Green Green Frag and stay on With no picture or sound. I have the d/o, green, and red on back soldered on fine but if the chip is enabled it frags otherwise its fine. DOES ANYONE HAVE ANY SUGGESTIONS OR ANYTHING? PLEASE
I did the pin header and it wouldnt boot it fragged when the chip was enabled.
When disabled it booted to the microsoft dashboard.
A couple of the pins were longer than other (basically the soldering wasnt good) so i took the header out and tried the wiring diagram on http://www.team-xecuter.com/forums/showthr...light=x2.6+wire )
With that i still got the same problem - Green Green Frag and stay on With no picture or sound. I have the d/o, green, and red on back soldered on fine but if the chip is enabled it frags otherwise its fine. DOES ANYONE HAVE ANY SUGGESTIONS OR ANYTHING? PLEASE