Installed Xecuter 3 on 1.6 and X led stays red when power is tapped or held

[demo38]

NICE!!!

That was it, I retouched the solder joints and BAM! Working like a champ!

Thanks for the help!

(Properly wetting the tip helps A LOT!!!) ...I know, I should have already known that, but I've learned a good lesson.

 

[wahoo75]

Had a similar problem. I just forgot to solder one point on the pcb to the mb. It was the far right top corner point. Double check the pcb first and then check the header pin. After rechecking your soldering, start the box up by holding the eject+power button to get into the Flash Bios. It you can see the blue screen, all you have to worry about is getting bios 1959 flashed.

I had the same problem. Red x3 logo and flashing blue LED light and xbox boots from original xbox bios. Rechecked all my solder points which were a good and I followed the eject+power button to get to the flash bios, IT WORKED !!!!!! LOL. Thank you for this post.