I bought a pro unlock kit and soldered it on but i don"t think I've done it 100% correctly since it wont show up in JF. Does anyone know someone here in the US that has experience with this and can help me?
LITEON 9504 Installing the pro kit for me?
- Thread starter sk8boy204
- Start date
GhostFace606
VIP Member
You must load your key and spoof to lt 1.91
But first you must treat it as a fat model so tick fat at the bottom of the dvdkey tab.
Then tick intro device.
Then jf will read the drive as a slim model.Then proceed.
Sent from android
But first you must treat it as a fat model so tick fat at the bottom of the dvdkey tab.
Then tick intro device.
Then jf will read the drive as a slim model.Then proceed.
Sent from android
Last edited:
jrjr6565
VIP Member
well now it come back with the "Type:" as being "Status 0x7F" under the Flash Chip Properties section. did I miss a pin when soldering it to the board?