I have a slim trinity.
I have used the slim qsb and slim post qsb.
So far I have dumped the nand four times all the same.
Created and Flashed ecc.
Booted xell and got dvd key.
Installed the cool runner (cutting the blue wire to 8cm).
The yellow wire is attached to point 1 on the post qsb and the blue wire to 50.
The console turns on and the green light on the ring of light flashes green continuously. After a few attempts the xbox booted, I have successfully booted 3 times. Each time though it was 6+ minutes and maybe another 5 failed attempts waiting for 5-10 minutes.
I decided to try 35 as seen in a few other posts, but the console got the green light on the ring of light, flashing green on the cool runner. But never booted after about 5 attempts of 5-10 minutes waiting. I changed it back to 50, but have since not been able to get the dashboard.
All I have done really is tin the points on the post qsb, and change the wire from 50 to 35 and back again. The last successful boot however, I installed xex menu and freestyle and have not been able to boot since. This was installed on the internal memory of the xbox while the blue wire was soldered to 50.
I have read the console should use RGH, however, currently it is flashed with RGH2. When I do try RGH jrunner automatically selects RGH2 after creating the image. Should I be forcing RGH all the time or should I use RGH2.
Also on the coolrunner you have points 123 etc, which of these should be bridged?
If someone can answer the top two questions this may be my issue. However, if not can someone possibly suggest what I could try.
I have tried both with the console in and out the case if this matters. My boot times when successful were 5+ minutes.
I have used the slim qsb and slim post qsb.
So far I have dumped the nand four times all the same.
Created and Flashed ecc.
Booted xell and got dvd key.
Installed the cool runner (cutting the blue wire to 8cm).
The yellow wire is attached to point 1 on the post qsb and the blue wire to 50.
The console turns on and the green light on the ring of light flashes green continuously. After a few attempts the xbox booted, I have successfully booted 3 times. Each time though it was 6+ minutes and maybe another 5 failed attempts waiting for 5-10 minutes.
I decided to try 35 as seen in a few other posts, but the console got the green light on the ring of light, flashing green on the cool runner. But never booted after about 5 attempts of 5-10 minutes waiting. I changed it back to 50, but have since not been able to get the dashboard.
All I have done really is tin the points on the post qsb, and change the wire from 50 to 35 and back again. The last successful boot however, I installed xex menu and freestyle and have not been able to boot since. This was installed on the internal memory of the xbox while the blue wire was soldered to 50.
I have read the console should use RGH, however, currently it is flashed with RGH2. When I do try RGH jrunner automatically selects RGH2 after creating the image. Should I be forcing RGH all the time or should I use RGH2.
Also on the coolrunner you have points 123 etc, which of these should be bridged?
If someone can answer the top two questions this may be my issue. However, if not can someone possibly suggest what I could try.
I have tried both with the console in and out the case if this matters. My boot times when successful were 5+ minutes.
