I've just got an IR6000 machine and I'm working on building a reflow profile.
I'm starting off with the bottom heater. Is the idea to get the top side of the board to a constant 170?
If so, is there a safe time to get the board to 170? ie should it take 5 minutes to start to level off?
Any help on this would be great!
I'm starting off with the bottom heater. Is the idea to get the top side of the board to a constant 170?
If so, is there a safe time to get the board to 170? ie should it take 5 minutes to start to level off?
Any help on this would be great!
