Hey guys, I've got another thread on an RGH 256mb Jasper that went south, and now I'm trying to figure out if the Cool Runner is still even working correctly.
Here's what I get: USB Nand-x hooked up to PC, One Red Light and one Orange/Yellowish on the NAND-X. Put the CR to PRG, (Mind you it is NOT Installed in an xbox currently.) and I get ONE Red LED on the Power light, and No Debug light at all. Is this correct?
When Flashing CR with JRunner it says successful, however, I couldve swore the first time I plugged the CR into my NAND-X and wrote it, there were two lights on.
Anyone know the CORRECT procedure for flashing a CR?
Also, my NAND-X Is still working correctly, tested a nand dump from an old JTag system and it matched the hacked nand that was written to it a while back. Im good there, I think. I didnt fry that.
Here's what I get: USB Nand-x hooked up to PC, One Red Light and one Orange/Yellowish on the NAND-X. Put the CR to PRG, (Mind you it is NOT Installed in an xbox currently.) and I get ONE Red LED on the Power light, and No Debug light at all. Is this correct?
When Flashing CR with JRunner it says successful, however, I couldve swore the first time I plugged the CR into my NAND-X and wrote it, there were two lights on.
Anyone know the CORRECT procedure for flashing a CR?
Also, my NAND-X Is still working correctly, tested a nand dump from an old JTag system and it matched the hacked nand that was written to it a while back. Im good there, I think. I didnt fry that.
