is my jr programmer done. not working

[johnny429az]

I have a slim trinity that I tried to rgh but would not flash to xell so I gave up . Before this happen the cr rev c would glitch green but wouldn't boot to xell. Now I removed everything try get it back to retail but cant load original nand. It doesn't power up anymore either. Jr programmer does not read or write my nand. I've resolder everything like 4 times still cant read or write. So im am asking for help cause I just gave up already.

 

[gavin_darkglide]

Soldering looks kinda crappy, but j-runner recognises it, so i would assume it is working. You could also try reflashing the JR-P with the latest hex file included with j-runner.

 

[johnny429az]

Yea its all beat up cause I've resolder like 4 times I switched the soldering to the back and still get lik 100 timeouts.how do you refresh you jrp with hex. Using jrunner v0.3 beta 4

 

[johnny429az]

k i hit the jrp update in jrunner but it says device not found looked in device manager on pc and its connected.

 

[johnny429az]

k connected now but ask for a file to update

 

[CptKlink]

Are you useing the JRP V1 or V2?

Browse to the common folder inside the J Runner folder and pick the PICFLASH_E_1_0_4_JRP1_ISD.HEX file for JRP V1 or the PICFLASH_E_1_0_5-JRP-V2.HEX file for JRP V2.

 

[johnny429az]

Updated jr programmer and solder wires to the back .still get time outs.

 

[BrockThunderjam]

Post pics of all the solder points you've touched, particularly stdby_clk. If you've damaged it your jrp won't communicate with the nand correctly.

 

[johnny429az]

What does error 250 block c1 and error 250 block 188 mean

 

[ablegepu]

probably a soldering issue

 

[johnny429az]

Close post moving on.

 

[BrockThunderjam]

Close post moving on.

Does that mean you sorted your issue? Would be nice if you could describe what the issue was for someone who may encounter the same problem going forward.