Just had major trouble with my Xecuter 2.6, sometimes would turn on first go, other times I would do the 2 times boot then red/green frag.
So tried resiting the XAPT3R a few tims (all 3 blue lights are one) but still nothing.
Reflashed the chip via HDD and Xecuter Programmer, still played up.
Turned it on today and nothing, wouldn't even see the chip at all, turned off chip and boots to original dashboard fine.
Tired to flash chip again via the programmer, but x2bm 2.3 gives me error code 0x1010 Failed to detect device.
Even tried the installed via pin header and wire way, but nothing, so looks like the chip mght be dead? But wait.....
I have an old Spider V1 and Xbit 1.5 that I could test on my Xbox, but same problem, would frag the same as when the 2.6 was installed, but original bios would load everytime.
Can anyone possibly help me out with this strange problem?
[my xbox is a v1.4]
So tried resiting the XAPT3R a few tims (all 3 blue lights are one) but still nothing.
Reflashed the chip via HDD and Xecuter Programmer, still played up.
Turned it on today and nothing, wouldn't even see the chip at all, turned off chip and boots to original dashboard fine.
Tired to flash chip again via the programmer, but x2bm 2.3 gives me error code 0x1010 Failed to detect device.
Even tried the installed via pin header and wire way, but nothing, so looks like the chip mght be dead? But wait.....
I have an old Spider V1 and Xbit 1.5 that I could test on my Xbox, but same problem, would frag the same as when the 2.6 was installed, but original bios would load everytime.
Can anyone possibly help me out with this strange problem?
[my xbox is a v1.4]