Soo anyways, I go to install my brand new X3 onto my 1.6 xbox. Everything seemed to be going fine. To make a long story short, it wasnt working so I proceed to check all of my solder points. All seemed good but the LAD2 point on the PCB board. So I attempted to make sure it was perfectly clean and had a good connection and I slightly lifted on the pcb board.. Well what do you know, the entire LAD2 point comes out... So now when I turn on my xbox, it attempts to boot twice and then I get a red light around the eject button.
Is my xbox toast or should I have someone experienced with electronics try to recont the points on the mother board above and below LAD2.
It it worth even trying or should I give up, buy a new xbox & x3 and start over.... :?:
Thanks for any help!
-Joe
Is my xbox toast or should I have someone experienced with electronics try to recont the points on the mother board above and below LAD2.
It it worth even trying or should I give up, buy a new xbox & x3 and start over.... :?:
Thanks for any help!
-Joe