Hey I have a Falcon motherboard installing a R-JTAG. I installed it and put xell on it, then hooked it up to rater to see if it was working. Here is the log for one glitch, the others are exactly the same. Does this mean I have it installed correctly and just need to find which of the 18 confgurations work or is the install bad? Thanks. I figured I would ask here instead so I don't mess with the wires if they are already good to go. Any help is appreciated thanks in advance. I don't think pictures are necessary because I think everything I need to know can be found in the log, I just don't know how to interpret the post results. I know the tutorial says 21 means its glitching correctly and am almost at optimal just thought it didnt hurt to ask here. Thanks.
Code:
Post 30 - VERIFY_OFFSET_4BL_CD Post 38 - SIG_VERIFY_4BL_CD
Post 38 - SIG_VERIFY_4BL_CD
Post 30 - VERIFY_OFFSET_4BL_CD
Post 38 - SIG_VERIFY_4BL_CD
Post 30 - VERIFY_OFFSET_4BL_CD
Post 30 - VERIFY_OFFSET_4BL_CD
Post 38 - SIG_VERIFY_4BL_CD
Post 30 - VERIFY_OFFSET_4BL_CD
Post 38 - SIG_VERIFY_4BL_CD
Post 30 - VERIFY_OFFSET_4BL_CD
Post 38 - SIG_VERIFY_4BL_CD
Post 30 - VERIFY_OFFSET_4BL_CD
Post 38 - SIG_VERIFY_4BL_CD
Post 30 - VERIFY_OFFSET_4BL_CD
Post 38 - SIG_VERIFY_4BL_CD
Post 38 - SIG_VERIFY_4BL_CD
Post 38 - SIG_VERIFY_4BL_CD
Post 10 - Payload/1BL started
Post 11 - FSB_CONFIG_PHY_CONTROL
Post 15 - FETCH_OFFSET
Post 16 - FETCH_HEADER
Post 1B - RC4_DECRYPT
Post 1C - SHA_COMPUTE
Post 1D - SIG_VERIFY
Post 1E - BRANCH
Post 20 - CB entry point reached
Post 21 - INIT_SECOTP
Post 20 - CB entry point reached
