I've Been Xecuted

[biggen6776]

my and my buddy got the xecuter finished the install arount 1:00am. it works great, we had lots of problems with the chip seating properly on the pins. we tweaked the pins alittle and now its all good. on the 18th i will be getting my 200gig hard drive and Xecuter front control panel. does any one knoe how hard it is to replace the control panel?


PS THANKS FOR ALL THE HELP BUDDY!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

 

[ozzy]

Very simply M8
Just clips out from the sides and one clip in the middle.
1 connector to your controller ports 3,4 ( usb )
1 connnector to X3 chip for lcd
old switch connector
You also need to take out your power and reset switch and buttons, also there is a silicon surround around the eject button easy to do only clips in

It took longer to route the wires then to fit the X3CP but all done in 10 mins

 

[TheDork]

Haha, You've been Xecuted!

 

[FREDANTHONY]

my and my buddy got the xecuter finished the install arount 1:00am. it works great, we had lots of problems with the chip seating properly on the pins. we tweaked the pins alittle and now its all good. on the 18th i will be getting my 200gig hard drive and Xecuter front control panel. does any one knoe how hard it is to replace the control panel?


PS THANKS FOR ALL THE HELP BUDDY!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

LOL, no problem man..that rebuild was a bit tricky..I think we shoulda knocked it out on the weekend rather than at 9 on a work night..hahaha. Let me know when you get yur hdd and x3cpl, if ya need some help let me know..Now read up and learn bout the bios and dashboards..hehehe.

 

[biggen6776]

where is a good place to get Bios help

where can i learn about the bios and operating system?

 

[FREDANTHONY]

well, we will go over some of that stuff, for now, check out xbox-scene.com for some info.

 

[cbovis]

Very simply M8
Just clips out from the sides and one clip in the middle.
1 connector to your controller ports 3,4 ( usb )
1 connnector to X3 chip for lcd
old switch connector
You also need to take out your power and reset switch and buttons, also there is a silicon surround around the eject button easy to do only clips in

It took longer to route the wires then to fit the X3CP but all done in 10 mins

Routing those wires was the most painful thing ever!

 

[biggen6776]

sounds like lots of fun. i cant wait to do it. ill be ordering it in a week or so.