FIXED J-R Programmer V1.1 read/write failed with Corona V3

M

milerwan

Junior Member
May 18, 2005
11
3
France
www.infinitydream.com
Hi,

I'm professionnal reseller of TX products and I encountered a real compatibility problem with JR Programmer V1.1.

I meet a persistent error when reading/writing on Corona V3 using a JRP V1.1 under J-Runner (288) :
Version: 01
Flash Config: 0xFFFFFFFF
IoTimedOut
IoTimedOut:No more bytes
Click to expand...
When I removed the addon "JR Programmer Speed ​​Upgrade QSB" and I update to JRP V1.0, reading/writing is OK.
With my NAND-X and new JRP v1.0, tests are OK too.

I have tested another JRP V1.1 and same failed result with same error message.

The R2C10 bridge is OK from start with an original factory resistance on board.

My question is as follows :
In fact, does the JRP V1.1 is compatible with Corona V3 motherboard ? :confused:

Thank you for the answers of those who have already tested.
 
M

milerwan

Junior Member
May 18, 2005
11
3
France
www.infinitydream.com
Thank you for the proposal, but update with "PICFLASH_E_1_0_4_JRP1_ISD_UPGRADE.HEX" already done.
Is there maybe an update that corrects this bug...?

Nobody having the same problem?
 
Last edited:
M

milerwan

Junior Member
May 18, 2005
11
3
France
www.infinitydream.com
What I am stunned !

However, this is not the first time I solder the "Speed ​​Upgrade QSB" addon but I totally forgot to remove the resistance this time. :facepalm:

Thank you for your vigilance, hoping this post will be useful to others. :)
 
  • Like
Reactions: DARKSUPR3MACY
You must log in or register to reply here.