J runner cannot continue error?

[Alien101]

Ok, so I've soldered all of the 7 wires to the correct points for reading the nand, but in jrunner I get no jr programmer logo also when I press f2 I get a cannot continue error

If jrunner doesn't detect the jrp will that also affect it detecting the console?

 

[john mathews]

yes , it want write or read did u install jrp drivers

 

[Alien101]

No how do I do that? when I plug the JRP into my pc I can see it in device manager but it has a yellow mark next to it

 

[Alien101]

Ok have done some reading and now know I have to delete old drivers and install new drivers but in the drivers folder there is no del.bat? and what driver is the update?

 

[Alien101]

UPDATE! problem 1 was that I didn't have jr programmer updated with the latest drivers after that the logo was appearing in jrunner

Problem 2: after that I was still get " version 10 0x00000000 cannot continue" touched up a bit of my soldering and after that I got good flash config I guess since the wires are so small it's crucial that they are connected properly

 

[demolition22]

try doing these steps in order,
1) connect the JR programmer to the Xbox
2) plug in the JR programmer to your computer
3) connect the xbox to power
4) push the reset switch on the side of the JR programmer
5) read the NAND

 

[BL4K3Y]

Does the console power up?

The correct Flash Config for a Trinity motherboard is 0x00023010.