im following a guide on how to read my nand corona v2 and i double checked my soldering and it looks good but when i connect it to the sd card reader and click read nand click my console type and go to click on my console in the window i dont think its showing up ive tried a few times and at first it would say its not the right size to be a xbox 360 nand and the second time it said failed to get disk geography, any idea what im doing wrong?
j-runner problem
- Thread starter chiefamallrod
- Start date
Martin C
VIP Member
Martin C
VIP Member
its a corona v2 4 gig on the latest dash and im using the slim proto v2 and the corona 4gb nand reader sd kit, trying to read nand.
Martin C
VIP Member
I'm not mad - just wanting to help others help themselves.
Retouch all points on your QSB just in case. Make sure you connect the PSU to the console BEFORE the SD adaptor goes into the reader.
Also try another reader.
ahh plugged psu in after sd card , and i tried the one built into my laptop and it didnt work so went and bought a 55 in 1 card reader ill be bumed if it doesnt work but what can ya do? ill have to run to the store again . thanks for the help buddy!
one last detail. wehn i click read nand and select corona 4g the green progress bar shoots up to half way and stays there? any idea why that is? and should i click full dump?
Martin C
VIP Member
What does J-Runner say? We need output from that too.
If you completed the template properly, I wouldn't need to ask.
If you completed the template properly, I wouldn't need to ask.
okay so the files finish checking when i open it. then i plug everything in select read nand then corona 4gb nand and click ok then it says corona 4gb selected manualy then the progress bar just shoots up to halfway and it doesnt say anythking after that. never finishes the bar. and idk what to do after that because my device doesnt pop up. im about to youch up my points like you recomended though
Martin C
VIP Member
new problem. two of the points on the nand reader where i solder it down are touching and i cant sepereate them. i think thats the problem.
well my nand reader broke :/ no im gonna have to wire it in somehow arnt i?
- - - Updated - - -
well a couple pads fell off of it, would it still work?
- - - Updated - - -
well a couple pads fell off of it, would it still work?
You could try to solder strands of wire to the trace maybe.
In my opinion it dosent look salvageable but someone correct me if i worng
-Chris
In my opinion it dosent look salvageable but someone correct me if i worng
-Chris