Will we have to remove the J2B1 QSB in order to replace it with the J2B1 v.2 QSB for the Coolrunner install?.
J2B1 QSB Removal?
- Thread starter valius21
- Start date
Martin C
VIP Member
How about point B...
Is that connected to the pads adjacent to the Hana chip?
Suppose its best just to wait.... I'm sure Ubergeek will cover it, he's good that way
I know a lot of people will be receiving their Nand-x & will be itching to do something with it, if your intentions are to use it with the Coolrunner then it might be worth waiting & using the J2B1 v.2 QSB.
Is that connected to the pads adjacent to the Hana chip?
Suppose its best just to wait.... I'm sure Ubergeek will cover it, he's good that way
I know a lot of people will be receiving their Nand-x & will be itching to do something with it, if your intentions are to use it with the Coolrunner then it might be worth waiting & using the J2B1 v.2 QSB.
Last edited:
Martin C
VIP Member
If you can solder then you can put that wire directly on the point. It saves you messing the board up trying to remove the old QSB.