Alright so I have been reading and trying things for the past 3 days to get this Jasper 16mb to work. I am at my wits end and would appreciate any advice you guys might have.
Brief history:
Tried to rgh box back in November for a friend. I have done a few Jtags in the past without problems but this is my first glitch.
Got good nand dumps, but had problems with power after flashing ecc. Traced problem back to the qsb and the stby_clk point but ended up lifting the pad when removing qsb and just doing wires.
At the time I didnt know about not getting power when the pad was lifted and thought that I had flashed a bad ecc file (wrong smc was my guess plus known problems from 360 multi builder 0.3)
I tried to reflash stock but couldn't read or write to nand and after trying to short it into spi mode a bazillion times I eventually removed the CR and gave up on the box.
So it's been sitting in the pile for the last 4 months or so and I decided to take another look at it. Figured out the stby_clk problem and repaired it to the trace. I immediately wrote the original nand back and was greeted by a whole new problem, RROD 0022 error after about 28 secs every time.
I reinstalled the CR and flashed a new ecc created from my original nand in hopes of getting anything at all out of this thing. The CR flashes green on boot and sometimes once or twice afterwards but the center green led on my rol never flashes, it is just a steady green. If I open my dvd drive it flashes and the rol spins when I hit the sync button but never when it should be booting.
I can give more information and post pictures but I have been through damn near every post and suggestion about this problem and nothing ever changes so my main question for now I guess is why does that light not flash? Maybe I'm just overthinking it.
P.s. No I have never gotten it to glitch or boot xell, nor do I have the cpu key.
Thanks for any help.
Brief history:
Tried to rgh box back in November for a friend. I have done a few Jtags in the past without problems but this is my first glitch.
Got good nand dumps, but had problems with power after flashing ecc. Traced problem back to the qsb and the stby_clk point but ended up lifting the pad when removing qsb and just doing wires.
At the time I didnt know about not getting power when the pad was lifted and thought that I had flashed a bad ecc file (wrong smc was my guess plus known problems from 360 multi builder 0.3)
I tried to reflash stock but couldn't read or write to nand and after trying to short it into spi mode a bazillion times I eventually removed the CR and gave up on the box.
So it's been sitting in the pile for the last 4 months or so and I decided to take another look at it. Figured out the stby_clk problem and repaired it to the trace. I immediately wrote the original nand back and was greeted by a whole new problem, RROD 0022 error after about 28 secs every time.
I reinstalled the CR and flashed a new ecc created from my original nand in hopes of getting anything at all out of this thing. The CR flashes green on boot and sometimes once or twice afterwards but the center green led on my rol never flashes, it is just a steady green. If I open my dvd drive it flashes and the rol spins when I hit the sync button but never when it should be booting.
I can give more information and post pictures but I have been through damn near every post and suggestion about this problem and nothing ever changes so my main question for now I guess is why does that light not flash? Maybe I'm just overthinking it.
P.s. No I have never gotten it to glitch or boot xell, nor do I have the cpu key.
Thanks for any help.
