JASPER Jasper 16 with CR4 XL and Demon installed not booting retail

T

tavishor

Full Member
Feb 15, 2005
36
0
Hello,

Could you please help me with an issue related to a Jasper 16 console with installed CR4XL and Demon that not booting retail image. I succeed to boot modified Nand image with no issue. I had also no issues reading / writing Nand.. no errors in the process, but not succeeding to boot retail image, leading to RRD every time. The console was updated before installing all the chips on latest dash, 17150.
The fusesets are following:

fuseset 00: c0ffffffffffffff
fuseset 01: 0f0f0f0f0f0f0ff0
fuseset 02: 000000f00f0f0000
fuseset 07: ffffffffffffffff
fuseset 08: 0000000000000000

I tried rebuild the retail image with LDV 16, but same result.. not booting and RRD.
Please help me with some suggestions.

Thanks!

 
T

tavishor

Full Member
Feb 15, 2005
36
0
Hi, I found out a pin on NAND-X QSB not soldered wright. I fixed this and now the console is booting ok the retail image, really quick. Unfortunately now the console is not booting anymore the R-JTAG image :(. I tried to write again the flash on Demon with same result.. not booting... I re-flashed the Demon with retail image and it is ok, booting ok as the XBOX retail image. I also found that the console is not booting anymore on XELL when I tried to write again the Demon with R-JTAG. Probably the good ideea is to open a separate thread with this new issue. I have also the pictures, but I''ll put all of it in the new topic.
 
You must log in or register to reply here.