I glitched a jasper 16mb with the coolrunner and the qsb's. After writing the .ecc it took two boots for it to turn on. I first tried without the dvd drive, and didn't seem to boot. After that I unplugged it, installed the drive and plugged it back in and boom, in less than 5 seconds it booted to xell reloaded. Got my cpu key, used ggbuild and then I proceeded to flash. The same happened, only this time the dvd drive was installed. I unplugged the console and then installed the ethernet cable and again, the console booted to the dashboard in less than 5 seconds. Since then it hasn't booted again. Any suggestions or solutions would be really welcomed.
RGH Jasper 16mb Boot Problems
- Thread starter kurokaru
- Start date
Martin C
VIP Member
Have you routed the wires as instructed in the tutorials? If so, you may need the 68nF capacitor between A and GND.
Yeah, I routed the wires under the console and glued them as far from that area as instructed. Since my last post it booted to xell reloaded one more time. I reflashed the nand with rawflash v3. For some reason now the 360 boots more frequently but it still takes some time to do so. Sometimes when it boots, the intro screen is really slow, or it freezes. Could this be anything to do with the x-clamp screws being put back too tight? I will see if tomorrow I can go to my local electronics store to buy a 68nF cap.
Last edited:
I installed a coolrunner last night on a small block 16mb Jasper and am having the same issue it powers on. The red light comes on the coolrunner and the green one flashes but no boot into xell. I have some caps so will try them tonight.
Martin C
VIP Member
freezing or stuttering is down to CPU_RST and CPU_PLL_BYPASS getting interference. Make sure these are well away from anything which will cause interference.
I would like to say that I just soldered the cap between ground and point A and its booting everytime in just seconds. Just like the user above me.