ANSWERED Jasper 16mb CR4 Demon will not boot.

[teozfrank]

If it booted grab your cpu key build your image and then tune it. Sounds like you almost there. :smile:

Yes seems like it thank you for your help!. Do I need to solder any of the capacitors to get better boot times or do I need to just change the dip switchs one by one?

 

[skillet34]

Every console is different. Start with post bit and switches first if you need to. If it boots quick leave as is, up to you. Caps are not always needed, tune to your system and liking. This is all covered in Ubergeeks guide........

 

[teozfrank]

Every console is different. Start with post bit and switches first if you need to. If it boots quick leave as is, up to you. Caps are not always needed, tune to your system and liking. This is all covered in Ubergeeks guide........

Changing the postbit had no effect on the booting at all besides only booting on the default. I will test tomorrow the dip switches just read it on the installation guide. I will let you know how it goes, thanks again !