Jasper 16MB no green light wont glitch - stock nand rrod 0022

[studiovpc]

heres the problem, read the nand from 16mb jasper, wrote xell back, booted xell and restored cpu key, keyvault, dvd key, fuses, everything is restored, after that point i have powererd it off.

flashed hacked nand back to it it wont boot, no green light on CR... so i checked my soldering points all ok, tried alternative points too, no go too..

after that i have tried to flash back retail nand, so I did that and it gives me rrod 0022

flashed hacked nand again just to make sure again, no green light on CR, tried another CR same story... but it doesnt give me rrod

forgot to mention it wont power to xell anymore either

never seen this problem done like 20 rghs so far...

any help?

thanx

 

[sick360mods]

how long does it take before it shows the rrod

 

[studiovpc]

about 5-6 seconds

 

[paul.86]

read read read read search search search

people get sick of anwsering same questions ldv

 

[studiovpc]

it's not ldv, I would say that if it was the problem, something else is buging it, looks like the CPU is dead cause it does not give any signals of life, green ligh on the CR should go green if it has cpu signal, this is not the case now...

I wonder if Martin C have something to say...

 

[paul.86]

Pics or soldering ??

If you flash stock nand and remove coolrunner and wires what does it do try this and try your stock nand and increase ldv by one report your findings please

Sent from my HTC Vision using Tapatalk

 

[studiovpc]

soldering is fine, like I said this is my 21st rgh I have pics but cannot upload them now, currently I'm at work

LDV is 6 when stock, also it is 6 when putting hacked nand

will try to incrase it when i get home

but the problem now is IT CANNOT BOOT TO XELL anymore that is what's bugging me, like CPU is dead, CR wont glitch, wont turn green light on

 

[paul.86]

could be any wire i done hundreds of rhg's and still have done full rewires in these cases

just try a rewire mate honest it mite shock you it does me

 

[studiovpc]

tried already, does not help, tried also alt points, still no results

 

[paul.86]

Did you remove wires and use stock?

Sent from my HTC Vision using Tapatalk

 

[studiovpc]

yup removed, tried to boot with cr, without cr, with cr set to prg, with cr on nor no go

when it has xell written to nand, it just wont boot, i get no rrod but it wont boot, cr wont glitch at all

 

[Martin C]

pics of your soldering please.

From experience, either your CPU_PLL_BYPASS point is damaged, the R7R17 resistance is not 10k or a damaged CPU is the cause.

 

[studiovpc]

Its cpu, checked it, dead

Sent from my HTC Desire using Tapatalk

 

[x23are]

how you found out the cpu is damaged??????