Jasper 16mb R-Jtag Won't Boot to Xell Every Time?

[Hypotoad]

I changed the post resistor jumper from the front of the header to the back, I am not sure if that is 10 ohms or 0 ohms, but it sure did help the boot times, it often boots instantly now and takes no longer than a few glitch cycles so for a RGH2+ I am very pleased with it.

Member Ionix kindly flashed the correct DVD key to the drive for me as someone had swapped out the drive before I got it and that works fine now, and I put Dashlaunch / FSD on it so it's all up and running now.

 

[lonix]

Glad to hear that you finished it.
now you will have to find a new project.

 

[Hypotoad]

Glad to hear that you finished it.
now you will have to find a new project.

I already got another Jasper 512mb off Ebay for a song, which is on dash 14699 so I will probably use a CR3 rev C - RGH1 on it, should be an instant boot, I had one with that but it was stolen 3 days after I got it during a breakin, we were living in Houston Texas at the time. I am going to use headers for reading the Nands now, I made up the connectors to go to my JRP V2, and have a bunch of 2mm x 2mm dual row headers, I am not keen on QSB's. I will just leave them in place, header pins are much easier to solder.

 

[lonix]

I agree, through hole solder points need to have pins through them