Jasper 16mb RGH No green light (on CR), no boot

[Maximize]

ok I am working on this console, and I did everything up to writing xellous. I go to boot it to get key info, but I get no green light and no boot to xellous.

I redid the orange, and green wire points. All other points look great. I rewrote xellous, and reflashed the coolrunner. None have made a change.

I do not have a camera to take macro photos with, any Ideas?

please let me know.

 

[viper0831]

Does it boot with the original nand flashed and the cr on?

 

[Maximize]

should I try turning it on in normal or program with the original nand?

 

[hodgie]

have you checked out MartinC roadmap thread? its a great place to start.
did you try booting your stock dash after wiring in your coolrunner?
can you write your stock nand back, swith the coolrunner to prog, then boot it?

 

[Maximize]

ok I tried in program it booted to stock, then I tried normal it BLINKED and booted

I will have to look up the roadmap I am not familiar with it.

since I got a blink what would the recommendation be?

rewrite xellous, or does that mean something?

 

[hodgie]

that verified that you most likely haven't damaged any critical solder point.

now you need to give more details.

what tool are you using to create ecc, to write the ecc
it may not matter, but are you using the capacitor?
no insult intended, but you are sure its a 16mb?