RGH Jasper 16mb won't boot

[tennisdude516]

I have been following Fib3r's guide, and have had no problems, until I tried to boot the Xbox into Xell to get my CPU key. I think it must be a soldering issue, but I am not sure where the problem lies. I have pictures, and would greatly appreciate and tips anyone might have. Thanks!

And yes, I used the alternate point for STBY_CLK point. It seemed easier than the original.

http://img252.imageshack.us/img252/3740/img0829h.jpg
http://img853.imageshack.us/img853/5254/img0828eh.jpg
http://img811.imageshack.us/img811/9264/img0827xq.jpg
http://img823.imageshack.us/img823/5042/img0826rm.jpg
http://img805.imageshack.us/img805/992/img0825h.jpg
http://img849.imageshack.us/img849/5046/img0824vd.jpg
http://img812.imageshack.us/img812/7494/img0823w.jpg

 

[RROD!]

your 3v3 looks like it is in wrong hole from the pic is it in the top row??

 

[xboxhack11]

What is your CB (Falcon ect).

What happens when you boot with eject button to get to xell.

Wiring looks pretty bad.

Hard to tell but wires are routed pretty bad (red wire wrapped around a resistor, I see another wire running over the top of a component)

At least try to re-route wires like in pics.

http://www.team-xecuter.com/forums/showthread.php?t=54423

http://www.team-xecuter.com/forums/showthread.php?t=74689

 

[Krafter]

Looks to me as is you attempted to solder to R4B24 by the HANA and damaged the trace. Is that true or is the pics deceiving me?

 

[xboxhack11]

I dont see the J2C3 wires in your pics (nandx). Did you forget them?

Scrap that, I see them.

 

[esbmaepo]

Put a capacitor on A to GND

 

[tennisdude516]

Looks to me as is you attempted to solder to R4B24 by the HANA and damaged the trace. Is that true or is the pics deceiving me?

I think you might be right. Looks like the solder came out. I will try to fix that.

As for the 3v3, I have it on the top row, in the middle of the 7, as it showed in Uber's original picture, even though it comes in at an angle.

The wire around the resistor was for the NAND read, and it caused me no problem. I can try to get a cap tomorrow, but other than that I am at a loss. Tried all sorts of fixes that others have had success with

 

[tennisdude516]

I solved my problem by using this link.

http://team-xecuter.com/forums/showthread.php?t=78681

I followed this step (but did not remove the resistor, and just created a bridge) and it works fine and is booting for me. Hopefully this helps people who might be in a similar rut down the road.