jasper 16mb wont boot

[DEL-BOY-TROTTER]

i have a jasper 16mb retail and i went and was going to install the rgh chip but i unsoldered it before i did any programing because i took that chip on my old zapher so i though it might mess it up but i unsolder the red and black wire and then i when to boot the console and the green light comes on and the4 fans and drive and all works but it wont boot onto dash just blank screen and it doesnt boot on the console like the green lights go around on the rf board

any suggestions if you need any pics or videos please ask and try do it asap

 

[Ticallion]

Firstly your description is terrible, I have no idea what you've done or what you are trying to do, so to clarify:

1 - You are trying to glitch a Jasper console?
2 - You took a coolrunner from a Zephyr and installed it into the Jasper?
3 - You've wired up the coolrunner to the Jasper and now wondering why it won't boot?

So if those are all correct there's countless reasons why this could be happening.

You need to clarify that you have read your nands on your jasper, flashed the .ecc to the nand and acquired your cpu key from the jasper - or if you even got so far as booting xell.

 

[-DoC-]

So you are talking about your Jasper?

You initially put the CR on your Jasper but decided to take it off the Jasper and put it on your Zephyr instead and now your Jasper isn't working?

Did you ever dump or flash the nand on your Jasper?

If the only thing you did was solder and unsolder without dumping or flashing you should post up pics because it doesn't like you ruined a point along the way.

 

[GamingRepairs]

If it wont boot reroute the wires. that sometimes is the cause happened to me before.

 

[frazzeld]

You could always do what you did before you installed it into your zephyr

 

[daftdog198]

Hi.
The console you took the coolrunner from will need the original nand writing back to it before it will boot.
The coolrunner will need reprogramming with the correct xsvf timing file that goes with the mainboard you are installing it to then you will need to install xell to the new mainboard to get your cpu key to build the hacked dashboard then that will need writing to the board