Jasper 256 Error: Reading Block C80

[F1Ride]

Alright Gents, I am going to reach out again to everyone for help on this. I have a Jasper 256 that is driving me bezerk!!!! I can write both Xell/Xellous to the Nand and can write the original Nand back to it and it works like original. My issue is that every time I make a Freeboot and write it to the Nand I get a Error 250 at block C80. The Jasper will load up and just Freeze at the XBox Logo. I can hit the menu button and pull up the menus, but everything runs slow and just goes to a black screen. I am using the Pin Header method with the ALT SMC Points and DVD Tray. Any help with this would be greatly appreciated, I have read all the Remapping threads and nothing seems to work for me. Any help would be greatly appreciated.

Thanks.

[/IMG]

[/IMG]

[/IMG]

[/IMG]

 

[seanr28]

just remap the bad blocks to other locations, Jtag tool can do this easily! All should then be fine

 

[F1Ride]

Didn't work, I 've tried that, and I've tried it XNand Healer as well.

 

[TilVl]

C80 is actually in the memory block.

Erase with nandpro, write xell update to xellous and then do freeboot. Or rewirte original nand format memry.

Nand only 3FF

 

[F1Ride]

When you say erase with Nandpro, do you mean the entire Nand or just the C80? Because I tried to erase the C80 and it gave me an error. What do you mean by ReWrite Original Nand Format Memory? This is bugging me, because I just did my buddies Jasper 256 and didn't have any of these issues.

 

[Martin C]

1. Restore your NAND. Make sure it boots ok.
2. Use NANDpro to dump the first 1000 blocks - you don't need anything dumped after this.
3. build freeboot with this 1000 block NAND dump and you should get a 64MB 'system only' Freeboot image.
4. Flash this to your console instead.

 

[F1Ride]

Martin, So I did restore my original and it booted fine, and then went ahead and dumped the first 1000, but ran into the 250 Error at C80 again. I created Freeboot and wrote to the Nand and got 250 Error C80. I turned on the box and it loaded but then Froze and i am exactly where i was before. Do you think there might be something wrong with Nand on the box itself, since I am continually getting this 250 Error: C80?