Jasper 256 Mb + CR Glitch + 2.0.14717

A

axelll

VIP Member
Mar 1, 2011
469
17
Everywhere
Something strange just happened, I glitched the console from the title after previously updating her to 14699.

Plugged in LAN, inserted the disc with FSD then I got an installation error which was telling me that dashlaunch cannot be run from 14717.

I freezed, went to settings and yes, I was on 14717. I guess it was a stealth update.

Anyway, I plugged in another HDD from another console with games and dash-launch installed. Dash-launch didn't start but I was able to play all the games from HDD straight from NXE.

Started the FSD installation disc again, unchecked install and configure dash-launch and I was in FSD...

I don't get it? Wasn't this update from microsoft supposed to kill the RGH?

Proof attached.
 
A

axelll

VIP Member
Mar 1, 2011
469
17
Everywhere
J-runner

Anyway, officially the console is dead, I can boot to xell every single time and it's booting fast but she does not start from the power button. I only have the original NAND since the console was at 2.0.14699, I have the fuses and kv. What should I do next?

TopTip(don't do this the way I did). Until FSD and Dashlaunch installed and configured TO BLOCK MS ACCESS NEVER plug your internet into the console !!!

---------- Post added at 17:10 ---------- Previous post was at 17:08 ----------

How can I revert her to stock and remove the CR??
 
Last edited:
A

axelll

VIP Member
Mar 1, 2011
469
17
Everywhere
In fact I cannot remember exactly how it was. I'll dump a NAND to see what CB I have
 
A

ARUNCREATIONS

VIP Member
Oct 1, 2010
195
23
INCREDIBLE INDIA
www.facebook.com
First check your CB with ur og nand and present 14717 nand if it increased u may wait for tx solution..
Otherwise the CB never changed
Get into xell check efuse value( how many " f " after keys ) and note it..use j runner dont forget to change 14699 and glitch image put your ldv value and build image and flash it to your console..

now
 
A

axelll

VIP Member
Mar 1, 2011
469
17
Everywhere
LDV value is still the same in XELL, 3, as it was before. I'm dumping the NAND now and I'll check with 360 Flash
 
A

axelll

VIP Member
Mar 1, 2011
469
17
Everywhere
...I guess I used the J-Runner with 14717 option...stupid...Should I flash her again starting with .ecc or should I write the original NAND back and start over?
 
A

ARUNCREATIONS

VIP Member
Oct 1, 2010
195
23
INCREDIBLE INDIA
www.facebook.com
So put 3 on ldv option and build 14699 image through jrunner , the CB has not changed because u dosent use ms original 14717 update..i think so u may revert to ur 14699 by directly using raw4 flash and nanddumb1.bin( change it to nanddumb.bin) to a usb stick.

Am i correct ...Admin or super mods ....?
 
Last edited:
  • Like
Reactions: axelll
A

axelll

VIP Member
Mar 1, 2011
469
17
Everywhere
Solved !!!, created nandflash with 14699 option, wrote nandflash from J-Runner and it's working. Dash is 14699. Thanx
 
You must log in or register to reply here.