Hey up everyone ;-)
After about 200 Boxes something new came up ;-)
Got this Jasper Yesterday. Checked Dash and and maybe available MU. Dash was good no MU sightable in the Dash Settings. So wired NAND-X up like usual and J-Runner came up with a 256MB Modell?
Flash Config: 0x008A3020
so thats right i guess. . . Went on like usually 2 Nand Dumps, compared, matched. Created .ecc anf flashed.
Used CR2 Rev.b booted and it took a sec till the fans where going mad and box shut down after another 2-3 sec. ???
Checked wiring al looked like always but resoldered them anyway. Nothing helped. No i just wrote back the Orig.Nand, took everything out again(CR and Nand-x Wiring) tried to boot and see the official Box Logo come up but...just for maybe a sec and then guess what... Fans going nuts again???
Checked Board for any solder where it should´nt belong but nothing. Just a usual Box thats trying to boot but can´t.
Now my questions and direction to sort the Prob is:
Why does J-Runner tells me its a 256 when i couldn´t see any available Memory @ Dash on my first check up?
Maybe theres the point?
Like always i thank all the lads here for any helpfull advise / Tip what could have gone wrong. If Pics are needed no Prob i post them but like i said its on Stock no just got left with that Fan / Nand / SMC Prob.
Cheers and THX
Seb.
After about 200 Boxes something new came up ;-)
Got this Jasper Yesterday. Checked Dash and and maybe available MU. Dash was good no MU sightable in the Dash Settings. So wired NAND-X up like usual and J-Runner came up with a 256MB Modell?
Flash Config: 0x008A3020
so thats right i guess. . . Went on like usually 2 Nand Dumps, compared, matched. Created .ecc anf flashed.
Used CR2 Rev.b booted and it took a sec till the fans where going mad and box shut down after another 2-3 sec. ???
Checked wiring al looked like always but resoldered them anyway. Nothing helped. No i just wrote back the Orig.Nand, took everything out again(CR and Nand-x Wiring) tried to boot and see the official Box Logo come up but...just for maybe a sec and then guess what... Fans going nuts again???
Checked Board for any solder where it should´nt belong but nothing. Just a usual Box thats trying to boot but can´t.
Now my questions and direction to sort the Prob is:
Why does J-Runner tells me its a 256 when i couldn´t see any available Memory @ Dash on my first check up?
Maybe theres the point?
Like always i thank all the lads here for any helpfull advise / Tip what could have gone wrong. If Pics are needed no Prob i post them but like i said its on Stock no just got left with that Fan / Nand / SMC Prob.
Cheers and THX
Seb.
