JASPER Jasper 512 RJTAG+

lonix

Senior Member
Dec 17, 2011
120
0
melbourne, Australia
Pictures of your install - Yes Attached
Dip switch settings - All Off (untouched)
Postbit jumpers - 10 Ohm Untouched from factory
Type of CPU_RST Cable Used - Default
Any QSB jumper/switch settings - No Qsb
Any caps installed - Nope
Any special Cb's used (Falcon CB on Zephyr etc) - Nope, Unless you count Aud_Clamp SMC Patch
Screenshots of RATER if used - I Have JRPv1.1, sorry


Soldering is a bit shifty but this box instant boots 100% of the time judging by the blinks on the dbg light, i get 1 quick flash and then boot every time.

very happy with this chip, thanks guys.

DSC_0310.JPGDSC_0316.JPGDSC_0315.JPGDSC_0314.JPGDSC_0313.JPGDSC_0312.JPGDSC_0311.JPGDSC_0308.JPGDSC_0307.JPGDSC_0309.JPGDSC_0317.JPG
 
Last edited:

lonix

Senior Member
Dec 17, 2011
120
0
melbourne, Australia
Updated JTAG wiring to Transistor Method which i did all underneath the board, and set post-bit jumper to 0 Ohms it now boots pretty much instant every time,

id say at a guess its one in every 15 glitches is a 2 glitch boot

im going to leave this alone now as Im sure it doesn't get much better
 

Attachments