RGH Jasper 512mb [DO I HAVE THE CORRECT EQUIPMENT?]

R

RGH Jake

Junior Member
Dec 6, 2011
11
0
1 x Xecuter NAND-X
1 x Xecuter CoolRunner - Ultimate Reset Glitch Hack
1 x Xecuter NAND-X To CoolRunner JTAG Cable


I have bought these, i installed the QSB that came with the nand-x. Though i seen in one of carolinagamers videos he has a different chip then mine.

Carolina Gamers:



MINE:




Reason being why i am asking it's because i installed the QSB and i can't read the nand :/ It said i usb device not found or something. I tried resoldering, and when i looked at his video i thought oh wow i must not have the right equipment?
 
N

neophyte5001

Senior Member
Nov 5, 2011
113
0
Missouri
RGH Jake said:
1 x Xecuter NAND-X
1 x Xecuter CoolRunner - Ultimate Reset Glitch Hack
1 x Xecuter NAND-X To CoolRunner JTAG Cable


I have bought these, i installed the QSB that came with the nand-x. Though i seen in one of carolinagamers videos he has a different chip then mine.

Carolina Gamers:

Link To Image

MINE:

Link To Image


Reason being why i am asking it's because i installed the QSB and i can't read the nand :/ It said i usb device not found or something. I tried resoldering, and when i looked at his video i thought oh wow i must not have the right equipment?
Click to expand...
The bottom one will let you read the nand and hookup the coolrunner, it's basically updated from the one you have for that purpose. They're pretty inexpensive and helps clean up the signal some also.

It looks like your soldering isn't solid on it anyway, I'd go ahead and remove it so you can install the new QSB when it arrives :wink:
 
Y

Yorkshire-Modz

Full Member
Dec 10, 2011
35
0
The QSB's you have are for the nand-x only whereas the one's carolina gamer has are the nand-x/coolrunner.
You should still be able to read the nand. Try removing the QSB and soldering the wires straight to the points :)
 
R

RGH Jake

Junior Member
Dec 6, 2011
11
0
Yorkshire-Modz said:
The QSB's you have are for the nand-x only whereas the one's carolina gamer has are the nand-x/coolrunner.
You should still be able to read the nand. Try removing the QSB and soldering the wires straight to the points :)
Click to expand...
Is there any pictures to the points?

I'm confused, and i'm losing all hope and i think my xbox might be dead :/ as it don't turn on.
 
I

iByee

Full Member
May 31, 2011
37
0
You get an error saying something about the USB when you haven't connected the power to your Xbox. If you haven't connected the power, go ahead and do that and try again.
 
You must log in or register to reply here.