RGH Jasper 512mb, Flashed using 0.5 builder with Xbox360 13604 Dashboard, 1 Red light,

[LINSONCHAN]

now this Jasper is a 512mb after installing official (13604)

Dump my nand using +r64 ... used 360MultiBuilder 0.5 to create nandflash.bin

write the nand .... boot no display, green light from TX flashes every few seconds...

I use the 0.5 to create my nand im still at Current Dash at 13604... didnt realize the 0.5 is for the 14699

Jasper 512mb, Flashed using 0.5 builder with Xbox360 13604 Dashboard, 1 Red light,

Please help

 

[keith6625]

well try to make your ecc with mulibuilder 4 and flash it to your nand and try that

and multibuilder 0.5 is not just for 14699 he added
Added Support for xeBuild and latest Dashboard version 14699

 

[LINSONCHAN]

well try to make your ecc with mulibuilder 4 and flash it to your nand and try that

tried that, using 0.4 and after on off on off on the xbox360 I get a 1 red light.

How long does a Jasper 512mb boot? this is my first time 512mb.

Do I need to turn on and off the unit?

 

[keith6625]

1 red light on the coolrunner or 1 red light on the xbox itself if the coolrunner is not flashing the green light then i would think it has something to do with you soldier job


you need to unplug the xbox not power it on and off

 

[LINSONCHAN]

1 RROR after a few on and off,

I dont know the process of booting the Tx, do I have to turn it on and off to boot, I waited for 30 sec and does nt boot so, I turn if off again and on again.... getting frustrated ... )

 

[keith6625]

so your coolrunner is not flashing green now?

your going to have to give all the info so i can try to tell where something went wrong
what would be nice

1 pic's of install as clear and as close as you can

2 what programs you used

3 what hardware did you use

 

[WestCoastConsoles]

Let it sit for a few minutes you were booting xell last night so its not your wiring unless you changed something whats the secondary error on the 1 red light

I have had a jasper that took up to 3 minutes to boot

 

[neophyte5001]

1 RROR after a few on and off,

I dont know the process of booting the Tx, do I have to turn it on and off to boot, I waited for 30 sec and does nt boot so, I turn if off again and on again.... getting frustrated ... )

Remember also to unplug the power from the xbox for one minute after flashing.

---------- Post added at 20:07 ---------- Previous post was at 20:06 ----------

now this Jasper is a 512mb after installing official (13604)

Dump my nand using +r64

Shouldn't that be -r64?

 

[WestCoastConsoles]

yes it should be -r64

 

[LINSONCHAN]

THANKS ALL, got thru this BB512 fine now,

Great help here.

 

[WestCoastConsoles]

glad you got it sorted