Jasper BB slow boot

[aclark20]

I've got a Jasper that's consistently glitching the first time near instant after it's plugged in, but on subsequent boots it's taking 3-5 minutes.

Wires are routed as shown avoiding the coils. Running with the Cap in place right now between A and GND. without it, it takes minutes to boot initially.

Is this a case where I should try the cap between the Pad and wire on point D??

 

[Martin C]

What behaviour are you getting from the green LED on the CR? Is it constantly flashing while it's trying to glitch?

 

[aclark20]

Yea, was consistantly flashing.

I got it sorted actually. The cap was laying down too flat and had an intermittant connection to a component on the CR. Bent it back up and its glitching in 10 secs consistantly

 

[Martin C]

you know you can just trim the cap legs to size? Sorts all these kinds of problems out ....