Hey guys,
I've fallen out of the scene in recent years, so the knowledge I have is a little behind the times-- this is basically a request to bare with me while I make a fool of myself. Last time I thought about soldering anything to my 360 was back when JTAG was a new thing, so it's been a while to say the least!
I've read through the roadmap, and it tells me that I should probably R-JTAG rather than RGH2, which is fine but can anybody tell me the major differences between the two? Pros and cons etc.? With the release of the CR4 XL, I'm still unsure about which road to go down. That being said, I'm unsure if there's even a benefit to using R-JTAG compared to CR4!
Any advice would be greatly appreciated, so thank you in advance!
I've fallen out of the scene in recent years, so the knowledge I have is a little behind the times-- this is basically a request to bare with me while I make a fool of myself. Last time I thought about soldering anything to my 360 was back when JTAG was a new thing, so it's been a while to say the least!
I've read through the roadmap, and it tells me that I should probably R-JTAG rather than RGH2, which is fine but can anybody tell me the major differences between the two? Pros and cons etc.? With the release of the CR4 XL, I'm still unsure about which road to go down. That being said, I'm unsure if there's even a benefit to using R-JTAG compared to CR4!
Any advice would be greatly appreciated, so thank you in advance!