Jasper NAND Size Problem

M

Maximize

Full Member
May 6, 2011
81
8
Ok history lesson, I purchased this console three years ago from someone who got it as a present . It sat in their closet since received, and its sat in my closet after I broke the seal and checked the dash version (8498). I decided to crack it open and rgh it. The flash config shows 512mb, the box shows 256mb, the dash shows no memory.

Manufacture date is 3/10 cb= 6751

It is the arcade version that came with banjo kazooie, and viva pinata

I read as 512 and created ecc, wrote it and installed my cr3 lite = no boot

I wrote back original nand, uninstalled cr3 lite = boots back to 8498 stock dash

I guess I'll try reading as 256 and write ecc. since I cannot select 16mb, unless I do a custom nand functions

Any ideas where I should go from here?

Thanks guys.
 
Last edited:
BrockThunderjam

BrockThunderjam

VIP Member
Jun 25, 2013
1,503
88
Maximize said:
Ok history lesson, I purchased this console three years ago from someone who got it as a present . It sat in their closet since received, and its sat in my closet after I broke the seal and checked the dash version (8498). I decided to crack it open and rgh it. The flash config shows 512mb, the box shows 256mb, the dash shows no memory.

Manufacture date is 3/10 cb= 6751

It is the arcade version that came with banjo kazooie, and viva pinata

I read as 512 and created ecc, wrote it and installed my cr3 lite = no boot

I wrote back original nand, uninstalled cr3 lite = boots back to 8498 stock dash

I guess I'll try reading as 256 and write ecc. since I cannot select 16mb, unless I do a custom nand functions

Any ideas where I should go from here?

Thanks guys.
Click to expand...
What flash config does JRunner give you? Just read 16MB and write the ecc. The ecc wont change things if it's 16, 256 or 512. If it's not booting there is an install problem. So, like GeekHeat said fill out the template please.
 
You must log in or register to reply here.