Jasper No A/V Problem

[LarryJr]

I hooked up a j-r programmer and read my nand.

powered on 360 to make sure it still worked (it did)

hooked up ****** glitcher, read nand, programed glitcher, programed nand

hooked up system to tv expecting to see xell and get my keys but all i had was a black screen and no audio. no ring of death either.

reflashed nand with original image and still no a/v

i am thinking i screwed up something when soldering in my ****** glitcher. everything on the front looks good but on the backside i had to solder to R7R17. i couldnt get it on there and kinda messed up the trace coming from resistor just above it. so i soldered it directly onto the bottom of the resistor. is this my problem? do i have to repair that tiny trace?

Ive included an image of the diagram i followed for installation and a closeup of r7r17. any help would be appreciated. thanks.

 

[Krafter]

I'm sorry but M.a.t.r.i.x isn't supported here. This is a Team-Xecuter support forum. Get yourself a CR4 or any other authentic TX chip and we'd be glad to help.

 

[LarryJr]

my bad.... sorry

how about a general question? does the trace from the resistor to r7r17 have to be intact?

I'm gunna get flamed for this aren't I?

 

[Antalpromille]

my bad.... sorry

how about a general question? does the trace from the resistor to r7r17 have to be intact?

I'm gunna get flamed for this aren't I?

This damage happens while using a competitor's product, go ask at their forum or get yourself a TX product.

Also, remove soldering from your skills since it's obvious a lie.

 

[LarryJr]

Haha. thanks