Hi i have a jasper 16mb 6750 here which i got from a friend which looked like had failed a system update. The dvd drive was unresponsive and seemed to be blank which is why im RGH to recover dvd key. I dumped nand and compared all fine. I created the ECC with multibuilder 0.4 and flashed to the console. I then programmed the coolrunner with impact and installed fine. The problem is when it is knocked on it just sits there with nothin on screen. When knocked on the green light on the coolrunner briefly flashes once and never again. Iv tried different tools to create the ECC with the same result aswell as repositioning the wires :frown: Do you guys think the nand could have been damaged before i even began? Help would be appreciated. Thanks.
RGH Jasper not glitching
- Thread starter dingle01900
- Start date
Martin C
VIP Member
Martin C
VIP Member
How did you flash the ecc over?
Flashing once and not again is a good thing as the coolrunner thinks it's glitched the console. Check your wiring again and make sure you dont have any cables near the coils under the fan shroud.
Flashing once and not again is a good thing as the coolrunner thinks it's glitched the console. Check your wiring again and make sure you dont have any cables near the coils under the fan shroud.
Thanks a lot martin! After rerouting the cables Xell booted almost instantly
Got that dvd key !
Martin C
VIP Member