I remember coming accross a thread similar to this before, but cant find it...
Anyway, I have a Jasper RGH2 that boots in excellent time (instant-1min) with my CPU_RST wire running around my cooling towers and coiled over the northbridge (use slim length CPU_RST wire). Running Timing File A.
Anyway, console boots fine, runs fine... just, when I go to power it off, the fans continue to run and the power light (up front) pulses about once every 15 seconds. If I turn it back on then long press the power, the console turns off. If I turn off from dash board, it also doesnt turn off correctly. In either case, the power brick light stays green. It will continue to run like this for at least an hour (i usually pull the power plug or turn it on then off again via long hold of the power button). Anyone familiar with this issue?
Anyway, I have a Jasper RGH2 that boots in excellent time (instant-1min) with my CPU_RST wire running around my cooling towers and coiled over the northbridge (use slim length CPU_RST wire). Running Timing File A.
Anyway, console boots fine, runs fine... just, when I go to power it off, the fans continue to run and the power light (up front) pulses about once every 15 seconds. If I turn it back on then long press the power, the console turns off. If I turn off from dash board, it also doesnt turn off correctly. In either case, the power brick light stays green. It will continue to run like this for at least an hour (i usually pull the power plug or turn it on then off again via long hold of the power button). Anyone familiar with this issue?
