Jasper Ruined?? Because of nandx? HELP!

[JHConsoles]

so heres the story in steps:
-i dumped my nand just fine
-installed CR3 Lite
-created ECC
-went to write ECC and it failed every single block. i tried other computers, different nandx wires, resoldered multiple times.
then i tried dumping my nand again AND IT WONT!

then i went to see if the console still worked and it wont power on! i dont know whats wrong

then i tried LPT and that doesnt even connect to my computer

please help me!

 

[john mathews]

http://team-xecuter.com/forums/showthread.php?t=96474 you need to fill out log with clear pics of install and coolrunner

 

[ultimate360]

Sounds like you shorted your nand points if its not powering on and you get no read

 

[JHConsoles]

Sounds like you shorted your nand points if its not powering on and you get no read

how do i fix that? :9

 

[ultimate360]

Start by removing your nand wires and try powering it on.

 

[frayed]

no one will help you until you fill out the [h=3]TEMPLATE: RGH/JTAG help[/h] and post pics of your install

btw the nand-x didn't ruin your console, pebkac ruined your console

 

[JHConsoles]

Start by removing your nand wires and try powering it on.

K then what after that didn't work

 

[Utmad]

K then what after that didn't work

As @Frayed says fill in the RGH template for support, the link is below in my sig...

 

[gazcoigne]

quite possible youve blown the SPI with dodgy soldering/wiring and now the console cant read the NAND hence the no R/W and no boot.

 

[jekdyell]

also possible you have damaged the stby clk point on the mobo.check you have not damaged the trace going to the r4b24 resistor also check the resistance of it should be 33ohms.also check you are getting 3.3v aswell.

and whats the error message you are getting when trying to read/write to the mobo.

 

[Utmad]

Need to complete this RGH TEMPLATE else your pissing in the wind !