R-JTAG Jasper Won't Load Xell (Occasional 0010)

[2615863]

I am having issues on a Jasper booting Xell. I have tried pretty much every combo but I cannot get it to boot. Original Nand boots fine
Console Type: (Jasper)
NAND size: 256
Dashboard version: e.g 2.0.16547
CB version: 6754
Screenshot of NAND details from J-Runner:

J-Runner log:
I restarted JRUNNER on accident, but I basically got 2 reads, they were compared, I selected JTAG/AUD_CLAMP/RJTAG, built .ecc and wrote it.
POST output from J-Runner :
This the typical 0010 (In this case it was stock Voltage, dips 5,7,8 on, top CPU_RST not R8C2 point)

[/COLOR]
Phat Selected
Version: 10
Power Up
Waiting for POST to change
Post 08 
Post 28 - FETCH_CONTENTS_3BL_CC 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 12 - FSB_CONFIG_RX_STATE 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 10 - Payload/1BL started 
Post 11 - FSB_CONFIG_PHY_CONTROL 
Post 12 - FSB_CONFIG_RX_STATE 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 11 - FSB_CONFIG_PHY_CONTROL 
Post 12 - FSB_CONFIG_RX_STATE 
Post 20 - CB entry point reached 
Post 20 - CB entry point reached 
Post 60 - INIT_KERNEL 
Post 20 - CB entry point reached 
Shutdown
[COLOR=#333333]

Image of R-JTAG board & Images of close-up soldering to motherboard:
http://postimg.org/gallery/95gha23u/ac15f55e/
Description of problem:Console will not boot XELL, And sometimes displays 3 red lights with error code 0010
Was the console working before you started: Y

 

[scott1503]

Read the install tutorial again you cou_rst is in the wrong place it wants to be on r8c2.
And have you tried every dip and voltage combo

 

[2615863]

Read the install tutorial again you cou_rst is in the wrong place it wants to be on r8c2.
And have you tried every dip and voltage combo

Thanks for the quick reply, and yes I'm pretty sure I have used all the combinations, but tomorrow I will rewire everything and document it here to obtain better help.
And I had it on r8c2 and it didn't seem to make a difference so I tried this point as a last resort but I got the same results

 

[gavin_darkglide]

I would be looking at post points

Post 20 - CB entry point reached 
Post 60 - INIT_KERNEL 
Post 20 - CB entry point reached

this is wrong. Please post a copy of the post log from the stock nand booting. Just disconnect the cpu_rst wire.

 

[stucknvegas]

Also it looks like the Aud clamp Green wire is not going to the correct location on the motherboard

 

[chronic1553]

your aud_clamp wire is going to the incorrect location.