A friend brought me a slim over to flash so before doing anything I went ahead and pulled the Dummy info off. Following this I did an outro / ATA reset twice to get it to reset. Opened the drive up and it was MXIC (03) so I went and installed a sputnik switch. This is probably my 6th sputnik install so I'm pretty comfortable in my ability with it, solder points all look neat and the trace looks good but when connecting back up to JF I'm just getting a no drive detected msg. Running 10 ohms on the switch, unlock is in the off position currently.
Just to test we hooked the drive up to the 360 and tried to start the console the make sure everything was OK and the Xbox just continually chain restarts prior to reaching dashboard. I checked over the PCB to make sure everything was OK and I saw a small break on the board directly below the solder points for the sata connection. It was a slight split in the green of the PCB so I went ahead and soldered that just incase it was the issue but sure enough I'm just experiencing the same problems.
Anyone have an idea of what might be wrong or is the PCB just fried?
Just to test we hooked the drive up to the 360 and tried to start the console the make sure everything was OK and the Xbox just continually chain restarts prior to reaching dashboard. I checked over the PCB to make sure everything was OK and I saw a small break on the board directly below the solder points for the sata connection. It was a slight split in the green of the PCB so I went ahead and soldered that just incase it was the issue but sure enough I'm just experiencing the same problems.
Anyone have an idea of what might be wrong or is the PCB just fried?
