hey guy i delete the drive to my jr programer and it still will not show up as a device on my computer why
jr programer
- Thread starter zachary117halo
- Start date
gazcoigne
BANNED
why do you need two threads? noone is going to answer you if you are so pushy!!
this is a support forum not a chatroom!!
your JR programmer probably needs flashed with the correct FW mine goes into bootloader mode all the time and needs reflashed.
remove all drivers and reinstall them, then use JRunner to flash the hex file to the chip.
the hex file is in the JR directory FYI
this is a support forum not a chatroom!!
your JR programmer probably needs flashed with the correct FW mine goes into bootloader mode all the time and needs reflashed.
remove all drivers and reinstall them, then use JRunner to flash the hex file to the chip.
the hex file is in the JR directory FYI
I had a similar problem with mine after using it a few times. It would disappear from device manager. Putting it into bootloader mode and reflashing the firmware usually fixes this.
i delete them but is there one in the computer i have to delete and how can i firmwall if it not pop up on device and went to jr runner and click on fw to firmwall it and it say there no device found
but do i need to but any thing or download anything cause i have pic hex firmwall and jr runner plese help me
open jrunner and click on tools then update jr firmware , did you reinstall drivers , go min add hardware and install new drivers if you have them if not you will have to download them
What colour LED lights up on the JR Programmer?
Also, is the small switch on the JR Programmer in the correct position? It sounds like it's either stuck in Bootloader mode or in Programmer mode but with no firmware loaded on.
From here http://team-xecuter.com/forums/showthread.php?t=86520
Also, is the small switch on the JR Programmer in the correct position? It sounds like it's either stuck in Bootloader mode or in Programmer mode but with no firmware loaded on.
From here http://team-xecuter.com/forums/showthread.php?t=86520
RED LED: Bootloader Mode (Switch to the left)
GREEN LED: J-R Programmer Mode (Switch to the right)
http://team-xecuter.com/xecuter-j-r-...-now-shipping/
drivers and install's at the bottom
as your having trouble and if you still can't figure it out read this
http://www.team-xecuter.com/forums/s...ad.php?t=85709
GREEN LED: J-R Programmer Mode (Switch to the right)
http://team-xecuter.com/xecuter-j-r-...-now-shipping/
drivers and install's at the bottom
as your having trouble and if you still can't figure it out read this
http://www.team-xecuter.com/forums/s...ad.php?t=85709
Last edited: