jr programmer reading writting nand after wrong nand flash

[seadanzig]

hi guys ive been given a 360 with a bad flash(got original .bin)
with j r programmer plugged in and xbox plugged in(not turned on)
j runner doesnt recognise controller. which i presume is due to bad flash.
ive tried shortings pins on the nand which didnt work.
so ive tried the 5 volt trick only at 5 volts still same no nand controller
ive lowered the voltage on my bench power supply to 1.9 volts

i get
junner log
===================================================
15 February 2014 20:28:20

J-Runner v0.3 Beta (4) Started


It's advised to run in administrator mode on Windows 8

Checking Files
Finished Checking Files
Version: 01
Flash Config: 0xFFFFFFFF
IoTimedOut

IoTimedOut:No more bytes!
FFFFFFFF
Falcon Manually Selected
Reading Nand to C:\Users\seadanzig\Desktop\jrunne\J-Runner\output\nanddump1.bin
Reading Nand
IoTimedOut
IoTimedOut:No more bytes!

any reason why the flash config changes from 0x00000000 at 5 volts then 0xffffffff at 1.9volts
ive also used a diy usb programmer too so i know the jrp is not knackered

ready to get my progskeet out shortly but just wanted input from you guys first

cheers neil

 

[oO Elite Oo]

You're not going to get help with what you posted. You refused to read the support template which is required at all time when asking for support.

 

[seadanzig]

Delete the post. I havent refused to read. I dont know what dashbord rev it is
it or cb. I havent posted pics of soldering cause I haven't had time
I was querying about why the voltage difference is causing different flash config

 

[oO Elite Oo]

More like you dont know what you are doing. Request for service... Simple.

 

[seadanzig]

Helpfull thanks