JR Programmer V2/JRunner Unable to Read NAND!

[midgetmods]

I'm new to the hardware side of modding, I seem to be having trouble reading my NAND in JRunner. Drivers are installed properly green light is showing up on my JRProgrammer, power supply to the xbox is hooked up properly and the 6 pin connector is also connected properly. I have tried unplugging the cables pressing the reset button on JrProgrammer but still no luck at reading my NAND. I feel as if my soldering points are off.
I Plan on installing CR4 XL's This is for a Trinity Slim Motherboard.

https://gyazo.com/1a8fef7b2aafa0e2ec20057e01f156bd

https://gyazo.com/9ca92a0d283b34e75bd54f293e2ebd8e

https://gyazo.com/d4370294a2494e123d01ee304b631e76

https://gyazo.com/c741825e0bfd29090af13fef74eff2a6

https://gyazo.com/861f784d5ea43ae4b4976b56baba4bfd

https://gyazo.com/2ff4d662000b395955c7a521d1f91e11

 

[Nintendo]

I'm new to the hardware side of modding, I seem to be having trouble reading my NAND in JRunner. Drivers are installed properly green light is showing up on my JRProgrammer, power supply to the xbox is hooked up properly and the 6 pin connector is also connected properly. I have tried unplugging the cables pressing the reset button on JrProgrammer but still no luck at reading my NAND. I feel as if my soldering points are off.
I Plan on installing CR4 XL's This is for a Trinity Slim Motherboard.

https://gyazo.com/1a8fef7b2aafa0e2ec20057e01f156bd

https://gyazo.com/9ca92a0d283b34e75bd54f293e2ebd8e

https://gyazo.com/d4370294a2494e123d01ee304b631e76

https://gyazo.com/c741825e0bfd29090af13fef74eff2a6

https://gyazo.com/861f784d5ea43ae4b4976b56baba4bfd

https://gyazo.com/2ff4d662000b395955c7a521d1f91e11

Just leave the minimum amount of exposed copper that you can on the wires. Is the ground connection solid?

 

[midgetmods]

Just leave the minimum amount of exposed copper that you can on the wires. Is the ground connection solid?

Yes power supply is plugged in and an orange solid light is lit on the power supply. Should I just try shortening the wires? Everything else looks good to me to be honest

 

[Nintendo]

Yes power supply is plugged in and an orange solid light is lit on the power supply. Should I just try shortening the wires? Everything else looks good to me to be honest

It's not about shortening the wires, but the exposed part. Yes trim it.

 

[midgetmods]

yeah thats what I mean't I'm sorry lol

 

[scott1503]

check the ground (yellow wire) usually the problem in these cases