JR Programmer Wiring Schematic Diagram

[taylorj]

Hello Everyone.

To cut a long story short I made a bit of a booby on the programmer itself.

I managed to rip off the connection for the SPI Nand.

I have managed to solder on the wires to the points but I need alternative points for XX and EJ.

If anyone can help me this will save me buying a new one.

Many thanks.

James

 

[Norris212]

Not sure if this will work or if you soldering iron is small enought but follow the XX and EJ traces up to where they go through restistors RN6 and RN7 and then solder to the right of the resistors.

 

[taylorj]

Not sure if this will work or if you soldering iron is small enought but follow the XX and EJ traces up to where they go through restistors RN6 and RN7 and then solder to the right of the resistors.

Will give it a try now. Cheers

 

[taylorj]

Reading Nand now!

You star!

Think once Ive RGH 1 this console the JR Programmer is going in the bin.

Many thanks.

 

[Norris212]

Its alright mate, i suggest you put it in the bin aswell because loose wires soldered to them tiny little point arent going to last long