Jtag Alt v2 Lifted Pads?

[morinzo]

A friend tried to install a rjtag and failed so he removed everything and brought it to me, while he was removing the Jtag Alt v2 he lifted 3 pads on the QSB. Is it possible to solider a wire to the motherboard and to somewhere else on the QSB to get around the pads he lifted?
Here is a pic of the pads that were lifted marked in red.

Nothing has been installed yet because I wanted to see if the QSB could be repaired.

 

[Martin C]

You can just use old skool JTAG wiring (diodes and bridge/resistor) as that's all the QSB is doing.

 

[XMonsterModsX]

U can use the traces on the qsb but your better off buying a new one

Sent from my GT-I9500 using Tapatalk 2

 

[morinzo]

He wants me to use this QSB so could someone tell me where to solider the wires to on the qsb?

 

[Martin C]

Yes - look at ANY of the diode JTAG installs. I just TOLD you.

If you can't sort it from that, take it to someone else to fix.

 

[morinzo]

Do I have this marked correctly to solder small jumper wires in to connect the matching colors? I used my meter to check for continuity on my personal rjtag and I think I have it correct.

Thanks for the advice Martin..


Update: After soldering the wires like the above pic it booted xell perfect on the first try and got the cpu key. Now to continue forward and build my img.

 

[bobgatz]

Almost right. The red and yellow pads go to the center pins on the switch. The blue is correct.