I have had my jtag for a while now and it has been running fine. I updated to the kinect dash a while back and it was fine too. Now today I boot it up and get a e79 error. I disassemble everything and resolder it all and even try reflashing freeboot with jtag tool 2.20. I still have this error. What should I do?
JTAG e79 -Not the xell problem
- Thread starter xbackslash
- Start date
- Jun 4, 2010
- 3,080
- 0
1. What type of board is it (xenon, zephyr, falcon, jasper etc)?
2. Did you try to boot the original nand dump and see if the console works fine?
3. Did you try booting your previous freeboot 9199 dash if you still had that?
Also if you are using generic diodes instead of the QSB for the JTAG these might have some issues and need replacing!
2. Did you try to boot the original nand dump and see if the console works fine?
3. Did you try booting your previous freeboot 9199 dash if you still had that?
Also if you are using generic diodes instead of the QSB for the JTAG these might have some issues and need replacing!