JTAG Jtag emergency

[xboxmoddz]

So after a long fiasco with a CB 4850 zephyr i decided just to put it back to stock and get rid of it. I flashed the original nand, and it doesnt boot, i tried all 3 dumps. I then tried dumping the nand i get errors all the way through the read.

I redid the wiring, i even tested the wires on another console and it reads fine.

I used the nandpro erase command as well and then put the stock nand on it with no go. I removed the nand chip and resoldered it back and i still have the same problem.

I dont get why its doing this

 

[TilVl]

Try shorting the nand.

 

[xboxmoddz]

tried that no go

i removed the nand chip and soldered it back on, same problem

 

[Xmods]

what color is the power brick instant read = internally shorted nand chip or bad solder

use a donor board flash your working nand to that then transfer the nand chip itself not an easy task but doable

 

[xboxmoddz]

it stays amber

does it matter which model board the nand chip comes from?

 

[TilVl]

No. You just need the nand from the original board you're jtagging.

 

[xboxmoddz]

i put the nand on but my iron slipped and i damaged 3 pads

in this picture 25, 26, and 30

25 and 26 do not were not connected to traces, 30 was so i soldered a wire to the point on the board and to pin 30

however i am not getting a connection on my pc

 

[Xmods]

you could of just read and wrote the information you don't have to actually swap the chip unless the board was dead

 

[xboxmoddz]

the old nand was def dead, so i had to replace it

now im stuck