Jtag Falcon error 0020 after writing Xell

[Djirko]

Hello,
so i faced that kind of problem for the first time. I got a jtagable falcon, but it refuses to boot me to xell and giving me this 0020 error. I tried both BAT41 and 1N4148 diodes, tried to add 100 and 330 ohm resistors between shorted points, tried without resistor. I leave pictures of my install ( its a little messy now, since its refuses to boot, didnt see point on wiring everything nicely ) and nand info. Btw console boots just fine with original nand back.

 

[Taijigamer2]

Have u tried writing xell with AUD clamp. Also your wiring is very long and exposed, try to get this as short as possible and insulated. Good luck.

 

[Djirko]

Have u tried writing xell with AUD clamp. Also your wiring is very long and exposed, try to get this as short as possible and insulated. Good luck.

Like i said, its messy since it didnt work at first and im tired of trying to make nice install every time i change everything I already was installed everything nice and tidy, but it didint work, so i started to test other stuf...
And yes, i tried to write aud clamp xell file, didnt help.

 

[Utmad]

Like i said, its messy since it didnt work at first and im tired of trying to make nice install every time i change everything I already was installed everything nice and tidy, but it didint work, so i started to test other stuf...
And yes, i tried to write aud clamp xell file, didnt help.

Yes but did you wire it using the AUD Clamp method, its not just the file that changes.

 

[Martin C]

There's always a point in wiring things nicely.

Remove all wiring for now. After writing xell, you should get E79.

 

[Djirko]

Yes but did you wire it using the AUD Clamp method, its not just the file that changes.

If you mean by soldering wire to aud_clamp point instead of ROL then yes. I didnt try one with transistors.

There's always a point in wiring things nicely.

Remove all wiring for now. After writing xell, you should get E79.

You mean remove all wiring, but keep xell written?

 

[crashxtrme]

Use this diagram, and cover the legs with heatshrink tubes, use a 100ohm for the jumper and rest in4148

 

[Martin C]

You mean remove all wiring, but keep xell written?

Yep, that's what I said.