JTAG jtag, fsd ok on usb but not hd

[jakekay]

hi all ..jtag, fsd ok on usb , it does say crash but can click to run fsd
i have copied fsd to hd and can run from hd but not on reboot,
if no usb stick it will stay in xbox system,
what/where is the boot priority ,usb or hd, no ini file
i have formatted hd with fat32 and tried hd that had been formatted from xbox.
.

thanks for help,great site, jk

 

[BrockThunderjam]

You need to edit your launch.ini to point to your hdd if you're wanting FSD to run from there on boot. Check out realmodscene.net. There are plenty of guides out there.

 

[jakekay]

hi.thanks for the info and realmodscene.net...
i found why a could only boot fsd from usb and not hdd,
i had been trying fsd on a 40gb fat32 hdd,after booting fsd with usb stick it would run fsd from hdd,
i tried a xbox formatted hdd(fatx),and copied from usb the fsd files and now it Fsd boots from hdd. SUCCESS...
now Question about eFuse ,am on lower than 7371 ,in jrunner i set dash to 16767,when can i remove r6t3.
should i update before playing any games........Thanks......jk

 

[BL4K3Y]

Question about eFuse ,am on lower than 7371 ,in jrunner i set dash to 16767,when can i remove r6t3.
should i update before playing any games

Update the JTAG image to 17150, run the 17150 system update, remove R6T3.

You don't *need* to remove that resistor - if you accidentally update your console with a retail system update (not likely to happen), you can install a CR4 .